True/False
Indicate whether the sentence or statement is true or
false.
|
|
| 1. | Beveled butt joints are used to
weld heavier pieces of metal together
|
|
| 2. | Corner joints on heavier
material should always be welded on one side so that the heat and stress doesn’t warp the
metal.
|
|
| 3. | An open corner joint in used on
heavy material and is the strongest of the corner joints.
|
|
| 4. | A square butt joint is used t o
weld heavy overlapping pieces of metal.
|
|
| 5. | An edge joint is used to join
two parallel or nearly parallel pieces of metal and is a very strong and reliable
joint.
|
|
| 6. | A lap joint is used to join two
overlapping pieces of metal
|
|
| 7. | Fillet welds are a basic weld t
hat is used when joining two pieces of metal without preparing the surface of the metal
first.
|
Multiple
Choice
Identify the letter of the choice that best completes the statement or answers the
question.
|
|
| 8. | Which of the following are
welded joints? a. | Butt joint | b. | T joint and lap
joint | c. | Corner joint and square joint | d. | Butt joint and T joint and lap joint are correct | | |
|
|
| 9. | Corner joints are used to weld
what kind of pieces together a. | rounded pieces | b. | two pieces that are approximately right angles to each
other. | c. | two pieces that are opposite of each other | d. | rounded pieces and two pieces that are opposite of each other are
correct | | |
|
|
| 10. | 1 inch metal and thicker can be
welded using what kind of joint? a. | lap joint | c. | double v or u
joint | b. | a triple pass edge joint | d. | t joint | | | | |
|
|
| 11. | This is a basic type of
weld used when preparing the metal before welding it into place. a. | tee weld | c. | fillet weld | b. | lap weld | d. | groove weld | | | | |
|
|
| 12. | This is a type of weld that is
used to join two pieces of metal that are approximately 90 degrees to each other, but the surface of
one piece of metal is not in the same plain as the other metal. a. | edge weld | c. | out of position weld | b. | tee weld | d. | lap weld | | | | |
|
|
| 13. | This joint is used on heavier
metal when welding can only be done on one side. this is also used when the load will not be
severe. a. | corner joint | c. | flare v weld | b. | half open corner joint | d. | single v groove weld | | | | |
|